This topic contains 10 replies, has 2 voices, and was last updated by 
-
Posts
-
When I close my Netcut then open it again nothing shows but when I restart my computer it shows but eventually it doesn’t let me change any of the devices settings.
-
does it give error message ?
-
No error message.
-
so when you set speed of one device, it does not not move or ? trying to understand “it doesn’t let me change any of the devices settings”.
it usually happen when you have ad blocker, and it pop up a window remind you to remove ad blocker or buy pro.
-
So to fully go into depth as I should have done in my previous post, basically after turning one device on and off after about 2-15 times I click the bar to move it to the policing column and nothing will happen it will just sit there not allowing me to turn the usage completely off. Then when I close it and reopen nothing is there and it just gives a debriefing on what is shown in each column. The only way I know and have been using to fix this is a pc restart.
-
This reply was modified 4 years, 7 months ago by
Cadencro11.
-
This reply was modified 4 years, 7 months ago by
-
-
does it still happen after reboot pc?
-
No after reboot it fixes and works fine for 10-20 minutes. Its just annoying.
-
do you mean netCut only works for 10-20 minutes , then became not response to any click / change request ? that you have to reboot PC?
In our testing, netCut been running over few days keep controlling few devices without problem. how many devices are you controlling at same time?
one thing that you don’t need to restart PC to reload netCut. you just need to restart aips service .
-
How do you restart aips service I think that might be it?
-
right click on “my computer” –> computer-management –> service –> Advance intelligent Protection service , right click it, restart
The forum ‘Support forum netcut. Email support: [email protected] and Discord link below’ is closed to new topics and replies.