This topic contains 2 replies, has 3 voices, and was last updated by 
-
Posts
-
When i refresh netcut to see if have a new device connect into network shows only devices that were scanned the first time also if i disconnect a device that is showing in netcut it will still be showing until I restart netcut, so everytime i need to restart netcut service to see who is on network.
i use netcut 3.0 on windows 10
-
I can’t get it to show devices on wifi even after resetting. not sure why it doesn’t work well. If I run it on my garbage old laptop on windows 7 it shows everything
-
This reply was modified 4 years, 4 months ago by
clonazepam.
-
This reply was modified 4 years, 4 months ago by
-
same
-Windows10
The forum ‘Support forum netcut. Email support: [email protected] and Discord link below’ is closed to new topics and replies.