Forum Replies Created
-
Posts
-
it sounds like your are on a pretty weak signal wifi network. when netcut start up, it sends plenty of packets that beyond your connetion’s capacity. are you be able to move your connection close to your WIFI router ?
is this your home network?
-
when you disabled ethernet connection, and reconnect via wifi. inside netCut , do you see gateway changed or your IP changed? if not, you need to restart netcut. you can do this by restart AIPS service , so simply reboot your PC. see if that works.
-
so you like the new feature of speed view ? 🙂
-
yup, new device will send broadcast when first time connected to your wifi, just as if your router has been rebooted
-
hello injectorx9 ,
“but i think if that’s the case it then it shouldn’t detect the other devices at all” —> not really.
when router reboot, all the client send broadcast , some router (apparently yours) forward that within same router level, despite the WIFI and Ethernet.
Try to make your PC connect with WIFI, or try to make the device you want to speed control connect with Ethernet, you will see 🙂
